Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Interfacing eS-128 to Existing NMEA 2K temp sensor
01-10-18, 04:20 PM (This post was last modified: 01-11-18 11:23 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Interfacing eS-128 to Existing NMEA 2K temp sensor
Hi , How do I display the temperature of an existing NMEA 2k Temp sensor on my eS-128 MFD. This happens to be an ambient air temp. I had an existing NMEA 2K network that is now connected to the eS-128. I see the temp sensor in the NMEA 2k diagnostics . I haven't been able to figure out how to display the temp on a either a chart as an overlay or elsewhere.
Thanks
Find all posts by this user
Quote this message in a reply
01-11-18, 11:21 AM (This post was last modified: 01-11-18 11:23 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA] Interfacing eS-128 to Existing NMEA 2K temp sensor
Welcome to the Raymarine Forum trr,

Please click here to view a related FAQ addressing this subject. In this case you will simply add Air Temp (listed within the ENVIRONMENT data group) to the MFD's Databar, Data application panel(s), or Databox.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)