Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Axiom transducer selection
01-30-18, 07:21 PM (This post was last modified: 02-01-18 04:59 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Axiom transducer selection
I would like to purchase a down vision or real vision transducer for my Axiom MFD.
I would like a thru hull transducer and if possible the dimension of the shaft of the new transducers that will work with the Axiom. My Axiom is an Axiom 9 with real vision.
My boat is a 1983 Tiara 31 open.

Thanks,
Joe
jbacile@gmail.com
Find all posts by this user
Quote this message in a reply
02-02-18, 09:55 AM (This post was last modified: 02-02-18 09:56 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA] Axiom transducer selection
Welcome to the Raymarine Forum Joe,

The hull's deadrise in the location where the transducer will be installed will need to be measured. A RV-212 transducer pair would be recommended for deadrise angles from 1° to 12°. The RV-220 transducer pair would be recommended for deadrise angles from 13° to 20°. Full dimensional data for these transducers may be found within Chapter 3.7 - Transducer dimensions - RV-2xx of the RV-2xx 3D Bronze Transducer Installation Instructions.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)