Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] deep water and cp200
03-23-18, 01:17 PM
Post: #5
RE: [CA] deep water and cp200
I have a completed the installation of the transducer and in reviewing the instruction manual, it stated that the unit should only be turned on when it is in water. It implied there is an overheating issue if you run the unit dry. I occasionally run my MFD while the boat is on the trailer to remain familiar with the software. How much time do I have running the cp200 dry before this overheating becomes an issue?
Last, is the cp200 unit functioning all the time or only when I call up the sidescan in the software?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] deep water and cp200 - Sallysea - 03-14-18, 05:25 PM
RE: [CA] deep water and cp200 - Sallysea - 03-23-18 01:17 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)