Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom to St8002
06-01-18, 12:17 PM (This post was last modified: 06-01-18 12:40 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Axiom to St8002
I have 2 new Axiom Pro units and the ST8002 is not showing up on them. I have an IPS course computer and the auto pilot is now connected to an ST/ST NG converter. Any suggestions? Would just changing the control head to a p70rs do the trick?
Thank you
Find all posts by this user
Quote this message in a reply
06-01-18, 12:44 PM
Post: #2
RE: [CA11] Axiom to St8002
Welcome to the Raymarine Forum halkau,

Q. Would just changing the control head to a p70rs do the trick?
A. Negative. Please click here to view a FAQ addressing this subject. Should it be desired to utilize LightHouse 3's Autopilot Controls feature, then it would be necessary to replace the autopilot control head with a p70RS Autopilot Control Head and the autopilot course computer with an Evolution EV-2 CCU.
Find all posts by this user
Quote this message in a reply
06-01-18, 02:45 PM (This post was last modified: 06-01-18 03:35 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] Axiom to St8002
Thank you for the rapid response
Find all posts by this user
Quote this message in a reply
06-01-18, 03:35 PM
Post: #4
RE: [CA11] Axiom to St8002
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)