Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Importing to Axiom Pro
06-03-18, 07:00 PM (This post was last modified: 06-04-18 01:40 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Importing to Axiom Pro
I am trying to import a GPX file containing routes and waypoints into Axiom Pro. The GPX file contains about 2500 waypoints. Each waypoint has a distinct name. There are also about 175 routes. Most, but not all, of the routes import into Axiom Pro. What could be the reason that some of the routes are not importing?
Find all posts by this user
Quote this message in a reply
06-04-18, 01:39 PM (This post was last modified: 06-04-18 01:41 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Importing to Axiom Pro
Welcome to the Raymarine Forum rsernau,

Please be certain that the MFD has been updated with LightHouse 3 v3.4.66 software. If so and the problem persists, then the most common reason for such issues is a failure of one or more of the constraints documented within the FAQ found here. After having reviewed your data and addressed any such violations, should the problem persist, then it would be recommended the routes be imported one by one until the offending route(s) be exported and then imported one by one (or in block) until the offending route(s) have been identified. Any routes which are identified to be problematic should again be checked against the aforementioned constraints and if no violations found, then please attach separate GPX files for each route which fails to import into the MFD. These will then be analyzed by our support team.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)