Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Tridata set up as "slave"
06-18-18, 04:51 PM (This post was last modified: 06-20-18 03:54 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Tridata set up as "slave"
Updated the electronics to Seatalkng, e95, itc5... Speed is not showing on the ST60 tridata instrument, despite being available on the i70s instrument. How to you change the ST60 to slave mode?

thanks
Don
Find all posts by this user
Quote this message in a reply
06-20-18, 03:54 PM (This post was last modified: 06-20-18 04:01 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Tridata set up as "slave"
Welcome to the Raymarine Forum Don,

Instructions for configuring the ST60 Tridata as a master or repeater of Depth and Speed (also affects temperature) may be found within Chapter 4.3 Intermediate calibration of the ST60 Tridata Owner's Manual. Should any issues persist with repeating data after having configured these settings then please indicate how the ST60 Tridata Instrument been interfaced to the system.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)