Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG] changing depth display
07-03-18, 11:31 AM (This post was last modified: 07-04-18 11:22 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG] changing depth display
Hello there,

I have a "new to me" sailboat with the Raymarine ST60 Plus depth sounder, and it will not display the depth in metres... I have followed the instructions in the owner's manual, and it cycles to feet, metres and fathoms, but I cannot set it to metres (it is currently set to feet and I can set it to fathoms).

thank you from metric Canada!!
Find all posts by this user
Quote this message in a reply
07-04-18, 11:25 AM
Post: #2
RE: [DG] changing depth display
HI aly

Thank you for your enquiry.

The units are set on the master display. Is the display that you are trying to set the units on the one that is connected to the transducer? If no, then set the units on the display which is connected to the transducer.

if yes, then is there another display in the system, for example multifunction display which is setting the units too?

Find all posts by this user
Quote this message in a reply
Post Reply 

Forum Jump:

User(s) browsing this thread: 1 Guest(s)