[CA] [CA11] Axiom 9 Screen goes haywire - only when moving

[Nickp]

Axiom 9 is fresh out of the box. Powered up and works fine as long as vessel is not moving. After a varied amount of time the screen starts to act on it's own...zooms in/out, menus are pulled down, goes into pan mode, changes vessel's position...and eventually cannot control touch screen at all. Again, this only happens when vessel is moving...if it is turned on in the slip/standing still, the unit will allow touchscreen commands all day.

To eliminate the vessel, I installed it in my vehicle...just to make sure there was nothing on the vessel to interfere with the Axiom. Same symptoms.

I performed a factory reset from "This Display" and also updated the software to 3.5.40 via Wi-Fi several times with varying results. The first update had no impact...the second update allowed the Axiom to function properly for close to 30 minutes and then the problem reappeared. After the third update the Axiom would fail within a couple of minutes of moving the vessel (this after working properly for some time before moving the vessel. Two more updates yielded nothing different.

Is there anything else I can do...?