Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Autotack user cal on ST6002 SmartPilot Controller
07-21-18, 03:00 PM (This post was last modified: 07-27-18 12:29 PM by Chuck - Raymarine - Moderator.)
Post: #1
[TG11] Autotack user cal on ST6002 SmartPilot Controller
Good Morning or Afternoon,

I am having trouble setting up my Autotack angle on my ST6002 SmartPilot Controller. I would like to specify a specific angle, rather than use the
Relative Tack option. Currently, I appear stuck on rEL (Relative Tack) and cannot get the display to change. I have tried both the user cal and dealer cal pages.

My system info: ST6002 Smartpilot. Version 5.0. X30 I20. 01696 hours. Two stickers on the unit: 1) E12098-P 1190171 and 2) 5624-010 41266140

Thanks in advance for you help!

David Tye
Find all posts by this user
Quote this message in a reply
07-25-18, 10:28 PM (This post was last modified: 07-27-18 12:29 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [TG11] Autotack user cal on ST6002 SmartPilot Controller
Hello David,

Sorry for the delay replying.

This, I'm sorry to say, an SPX pilot limitation: the SPX pilots didn't support a manual/fixed tack angle. There was an error in the handbook that said that they did (I have a feeling that that was corrected in a later issue of the handbook, but haven't checked back.)

Regards,
Tom
Quote this message in a reply
07-27-18, 09:35 AM (This post was last modified: 07-27-18 12:29 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [TG11[ Autotack user cal on ST6002 SmartPilot Controller
Thanks Tom, appreciate the response and information...

David
Find all posts by this user
Quote this message in a reply
07-29-18, 09:02 PM
Post: #4
RE: [TG11] Autotack user cal on ST6002 SmartPilot Controller
No problem.
Tom
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)