Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG] Buzzing Noise Smartpilot S1
08-21-18, 08:49 AM (This post was last modified: 09-03-18 09:52 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG] Buzzing Noise Smartpilot S1
Hi,
I have replaced my Raytheon type 100 course computer with a Smartpilot S1.
The old course computer broke down for second time, same transistor (IRFZ44N) failure. I prevents the clutch from engaging/disengaging.
My system is 12V and has a ST6002 control unit and a Lewmar DU130 Direct Drive connected via a linkage to the rudder axle.
I have to interchange the output cables to the drive (A&B) to make work.
The boat is a light displacement fin keel cruiser-racer (39ft, ca 8tons).
It works in normal conditions, but not on moderate swell or high wind.
But the thing that worries me is that as soon as I press Auto on the control unit starts a electrical buzz on the drive unit. Or so it seems, difficult to locate the exact point in the lazarette.
I never have this buzz with the type 100 course computer. So I wonder what could it be.

Thanks in advance for any help,

Carlos
Find all posts by this user
Quote this message in a reply
09-03-18, 11:51 AM
Post: #2
RE: [DG] Buzzing Noise Smartpilot S1
Hi cbarrer6

Thankyou for your enquiry

The buzzing - if it is coming from the drive could either be mechanical, maybe the drive belt slipping possibly, or the clutch coil buzzing? The S1 computer is a small unit to be driving the Lewmar drive and I would have suggested an S2 as a more suitable course computer.

The S1 is going to struggle to provide enough power to the drive.

Regards
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)