Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Adjustments to +10 and -10 heading commands
08-25-18, 12:33 PM (This post was last modified: 09-13-18 02:20 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Adjustments to +10 and -10 heading commands
My preprogrammed P70s controller heading commands (+10 or -10) need adjustment. Entering +10 or -10 causes the vessel to change course by approximately +6 or -6 degrees according to my compass and not the full 10 degrees. How do I make the small adjustment necessary to ensure the full +10/-10 degree changes are executed? I have a wheel auto pilot without rudder reference transducer and EV-1.
Find all posts by this user
Quote this message in a reply
09-13-18, 02:23 PM (This post was last modified: 09-13-18 02:24 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Adjustments to +10 and -10 heading commands
Welcome to the Raymarine Forum WEG3,

Autopilot control heads have no such adjustments. Was the autopilot operating in Auto mode or in Track mode when the reported symptom was observed? What value has your Evolution autopilot's the Response setting been set to? What version of software is installed within the autopilot's EV-1 CCU? What was the maximum deviation value detected by the autopilot after it had completed detecting magnetics?
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)