Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] c95 to existing ST1 daisy chain
09-23-18, 08:27 AM (This post was last modified: 09-24-18 09:01 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] c95 to existing ST1 daisy chain
Hi chuck,

Thanks for the welcome, and sorry for the delay!!!

Attached is a diagram of "what I think" is correct, to the best of my cable tracing abilities...

Basically I'm looking for the simplest way to connect a new refurb c95 to the existing ST1 network... An ST1 loop in the navpod is right there (new cable routing A in blue)

Also, I can run 0183 cable back to the Type 300 (new routing B)

Additionally I'm planning on throwing in a new VHF with 2k and 0183 capabilities to display AIS data on the c95

Components in the system are:
Autohelm Type 300 course comp
Ray E12102 Smart heading sensor w/ext flux
ST80 Masterviews
ST80 AP keypads

If I tie the c95 and VHF/AIS via 0183 back to the 300, will the c95 display the ST1`data and control? i.e. convert ST1 speed/depth/wind/AP to 0183?

I'm sorry for what must seem like a simple question... I'm a little overwhelmed!

Thanks again!

HS
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] c95 to existing ST1 daisy chain - HappySailor - 09-23-18 08:27 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)