Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Ev100
11-09-18, 05:57 PM (This post was last modified: 11-13-18 12:29 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Ev100
Just received my autopilot and stumped out of the box. With regard to the ACU-100 and the Seatalk ng screw terminal next to the rudder terminal am I to understand, I have to cut one of the sealed plug connections off the black and blue backbone Seatalk ng cable and lay bare the five wires within the backbone cable so I can individually attach each wire to the screws at the Seatalk ng five screw terminal?
Find all posts by this user
Quote this message in a reply
11-13-18, 12:39 PM (This post was last modified: 11-13-18 12:42 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Ev100
Welcome to the Raymarine Forum bwconquest21,

Negative. Per Chapter 4.3: ACU-100, ACU-150 connections of the Evolution EV-1 and ACU Installation Instructions, the ACU connects to the SeaTalkng® backbone using the supplied Spur cable, not a Backbone cable. A Stripped End Spur Cable is provided within the kit to accommodate this end. As shown within the diagram below, this Spur cable will be connected to a spur socket (white) within a T-Piece of 5-Way Connector within the backbone.

[Image: attachment.php?aid=2446]


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
11-15-18, 08:24 AM (This post was last modified: 11-15-18 10:02 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] Ev100
Thank you. I subsequently found the Spur pig tail under the package material.
Find all posts by this user
Quote this message in a reply
11-15-18, 11:01 AM
Post: #4
RE: [CA11] Ev100
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)