Raymarine forum / Raymarine Forums / Radar v / Radar -- no data source followed by operation

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Radar -- no data source followed by operation
05-19-16, 10:11 AM
Post: #6
michaellutz Offline
Junior Member
**
 		Posts: 8
Joined: Feb 2016
Reputation: 0
RE: Radar -- no data source followed by operation
I made a new discovery today. The radar page on my E120 continued to show the "no data source" message for the better part of an hour during which I turned the instruments on and off multiple times. The I checked the boat voltage and it was about 12.5 V. I then turned on the battery charger which brought the boat voltage to about 14.5 V and the scanner warmup message immediately came on. The spec says the voltage can be as low as about 9 V so was well within spec at 12.5 V.
What does this tell you?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Radar -- no data source followed by operation - michaellutz - 05-19-16 10:11 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication