[DG] [DG] Thermal Camera

[tegarre]

Thanks Derek.

I purchased a FLIR JCU, part number 500-0385-00, and configured it to my T200 camera using an Ethernet network connection. The JCU receives power through a PoE connection. The camera is powered by a PoE. I used the Web browser running on my PC to change the JCU network address to a static IP address 10.21.0.16. (The T200 camera has static IP address 10.21.0.5.)

Upon powering up the PoEs, the JCU identifies the camera and allows me to control some of the camera. It will change the zoom via the joystick puck and allow me to change the JCU to standby mode in the Power Menu. The JCU will not allow me to take to System Standby mode, not can I change the image settings or configure the camera by means of on-screen menus. The JCU MENU button will not turn the on-screen menu on, pressing the JCU MENU button has no effect. Pressing the JCU COLOR button has no effect, and thus the JCU will not change the palette (Color Thermal enabled) or change the day/night display (Color Thermal disabled).

I can change these with the PC using the Web browser.

I understand from the operator manual that some JCU buttons have no effect on the T200 camera, but its not clear which ones. Which ones should work?