Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] connecting ST 1000
01-10-19, 08:59 AM (This post was last modified: 01-10-19 09:47 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] connecting ST 1000
Can I connect ST1000 directly to the battery bypassing the the panel? I have only had the boat (alberg 22) for one season and the wiring is a mess, it will take me a while to figure it out.
If yes I would need a fuse in line, correct? Tnx in advance, Jerry
Find all posts by this user
Quote this message in a reply
01-10-19, 10:12 AM (This post was last modified: 01-10-19 02:04 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] connecting ST 1000
Welcome to the Raymarine Forum Jerry,

Proper installation of marine electronics includes protecting the circuits which supply them with power. In the case of the ST1000, it is recommended that the circuit supplying it with power be protected wtih a 12A fuse of 10A thermal breaker.
Visit this user's website Find all posts by this user
Quote this message in a reply
01-10-19, 01:30 PM
Post: #3
RE: [CA11] connecting ST 1000
thank you, so I assume its ok to hook up the tiller directly to the battery.
Find all posts by this user
Quote this message in a reply
01-10-19, 02:03 PM
Post: #4
RE: [CA11] connecting ST 1000
Jerry,

Q. so I assume its ok to hook up the tiller directly to the battery.
A. You may do so only if you include the previously specified circuit protection (i.e. fuse or breaker).
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)