Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] ST60+ Low Depth Alarm Setting Blocked?
01-17-19, 09:42 PM (This post was last modified: 01-20-19 08:09 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE:[TG11] ST60+ Low Depth Alarm Setting Blocked?
Hello Dave,

You can only configure alarms on the device that provides the data: is the depth transducer connected to the ST60+ Depth, or the A70D? If the latter, you need to configure the alarm on the A70D. Note that alarms aren't necessarily passed through convertors.

Also: convertors plural? You should only have 1. More than one convertor implies two separate ST1 or STNG networks, which can cause all sorts of data problems including data loops. You should have a single ST1 network, a single STNG network, and a single point of connection.

Regards,
Tom
Quote this message in a reply
Post Reply 


Messages In This Thread
RE:[TG11] ST60+ Low Depth Alarm Setting Blocked? - Tom - Raymarine - Moderator - 01-17-19 09:42 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)