[CA] [CA11] Axiom 12 Pro Flush mount

[Oregoncme]

I've done MANY installs mounting these IN the dash, mostly fiberglass or aluminum. The only thing your going to have to do, is be super careful drilling the four holes (one in each corner of the plotter already) in the the acrylic. Now, honestly, it depends how stout the acrylic is. You only get maybe 1/2" AROUND the plotter for a mating surface (exactly like the gasket). If the plotter, bouncing on the boat, pressing on the screen, and some pressure to stabilize your balance is MORE than that surface area allows for (and not causing it to crack), then your good. The supplied surface mount gasket may be used between the underside of the plotter face and the new acrylic dash. Its pretty darn flush and skinny. Once the plotter is installed, the plotter face is only proud 1/2". If it isn't, you will want the Axiom XL series. They mount completely different and will be VERY self-supporting. Fiberglass and aluminum happily support that weight. Acrylic may not...

I hope that helps.