Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] can LH3 support third party IP camera that is higher than 1080P now?
02-07-19, 08:36 PM (This post was last modified: 02-08-19 03:22 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] can LH3 support third party IP camera that is higher than 1080P now?
can LH3 now support third party IP camera that is higher than 1080P now?

I have a Axiom MFD would like to buy a 4K camera to connect to Axiom.



> - Network/IP Cameras (ex. Raymarine CAM210, CAM220, CAM200IP, FLIR
> M132/M232 Thermal Cameras (MFDs running LH3 software only ... MFDs
> running LightHouse II software will be able to display video only from
> these thermal cameras), etc.) and video encoders (ex. Axis M70 Series
> Encoders (M7011, M7014, M7016), etc.)
> IP Camera Product Requirements:
> - Must support H.264 video compression
> - Must support RTSP (Real Time Streaming Protocol)
> - Must support ONVIF Service Detection (ONVIF User Authentication MUST
> BE DISABLED)
> - Must have DHCP enabled & Dynamic IP set to ON
> - 720p resolution or 1080P

http://www.youtube.com/njfishing1 - from Captain Steve
Find all posts by this user
Quote this message in a reply
02-13-19, 01:21 PM
Post: #2
RE: [CA11] can LH3 support third party IP camera that is higher than 1080P now?
RAY18,

Although one may may use a 4K IP camera with the Axiom MFDs, the Raymarine system will not benefit visually, as it will be viewed in 720P or 1080P.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)