Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] After softwware update
02-18-19, 12:24 AM (This post was last modified: 02-20-19 11:08 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] After softwware update
I have 4 axiom 9 mfd. (2) at the console and (2) at the bow. I have one as the master and two of the units networked to it -

After the latest 3.8.97- I had to do a factory reset because the unit wouldn’t recognize transducer. After getting that figured out. I’m not able to read the water temp at the master unit. I’m getting -.-

Second issue- one that I hadn’t noticed before. I’m losing bottom on plane at higher speeds. Trolling speeds are ok most of the time. I have a p-72 and rv-100.

Do I need to assign where to get the water temp from ? Data source? Reinstall software?

Thanks in advance
Find all posts by this user
Quote this message in a reply
02-20-19, 11:10 AM
Post: #2
RE: [CA11] After softwware update
Welcome to the Raymarine Forum Copefishin,

Has the P72 transducer been installed inside of the hull?
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)