Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Smart Pilot LTP13
03-03-19, 12:30 PM (This post was last modified: 03-04-19 12:08 PM by Derek - Raymarine - Moderator.)
Post: #1
[DG11] Smart Pilot LTP13
From the Smart Pilot Service Manual:
"Rate gyro
1. Using a DVM, measure the voltage at the rate gyro output (LTP13). If the rate gyro is serviceable, the
nominal reading is 2.5 V ± 0.3 V."

Where is LTP13?
Find all posts by this user
Quote this message in a reply
03-04-19, 12:09 PM (This post was last modified: 03-04-19 12:16 PM by Derek - Raymarine - Moderator.)
Post: #2
RE: [DG11] Smart Pilot LTP13
Hi mcarroll51

The test point is located withinn the SPX course computer and is shown below
[Image: attachment.php?aid=2701]

regards
Derek


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
03-04-19, 04:14 PM (This post was last modified: 03-04-19 04:31 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [DG11] Smart Pilot LTP13
Thanks. Can you direct me to it on the circuit board?
Find all posts by this user
Quote this message in a reply
03-05-19, 04:56 AM
Post: #4
RE: [DG11] Smart Pilot LTP13
Hi mcarroll51

Troubleshooting/diagnostic/repair information which extends to opening a product's case to perform any specific testing or repairs to the product's circuitry is outside of the scope which is to be supported via Raymarine's Forum.

We are unable to give further details on the forum since this level of repair is supported only through the Raymarine approved dealer network.

Regards
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)