Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] B&G Zeus with SPX5 and ST70
04-01-19, 08:42 AM (This post was last modified: 04-01-19 10:58 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] B&G Zeus with SPX5 and ST70
I beleive I have this wired correctly but the B&g does not recognize having an autopilot. The SPX5 is in the device list. I can setup a route and activate it and then hit track on st70 and it works. My question is should I be able to control the spx5 directly from b&g for +1 +10?.
Find all posts by this user
Quote this message in a reply
04-01-19, 12:09 PM
Post: #2
RE: [CA11] B&G Zeus with SPX5 and ST70
Dkdoyle,

While it is possible to interface a third party chartplotter / MFD to a Raymarine autopilot and to command the autopilot into Auto, Track, and Standby modes via the autopilot's control head, it will not be possible to command the autopilot into these modes, dodge (+/-1, +/-10), or adjust the autopilots settings via a third party chartplotter / MFD.
Find all posts by this user
Quote this message in a reply
04-04-19, 07:14 PM (This post was last modified: 04-05-19 06:08 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] B&G Zeus with SPX5 and ST70
Thanks that is exactly what I needed to know
Find all posts by this user
Quote this message in a reply
04-05-19, 06:09 AM
Post: #4
RE: [CA11] B&G Zeus with SPX5 and ST70
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)