Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] eS98 to networking switch
04-14-19, 07:26 PM (This post was last modified: 04-17-19 03:56 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] eS98 to networking switch
This winter I added a Backbone and Networking switch. I'm having difficulty connecting the switch to my eS98. What cable is used from the switch and where on the back of the eS do I connect?
Find all posts by this user
Quote this message in a reply
04-17-19, 03:56 PM
Post: #2
RE: [CA11] eS98 to networking switch
Welcome to the Raymarine Forum Seahorse,

What model of network switch did you install?
Find all posts by this user
Quote this message in a reply
04-19-19, 05:45 PM (This post was last modified: 04-22-19 12:42 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] eS98 to networking switch
HS5. The book says to use a e series A06061. It does not plug into anything I own.

What did I order wrong
Find all posts by this user
Quote this message in a reply
04-22-19, 12:48 PM
Post: #4
RE: [CA11] eS98 to networking switch
Seahorse,

The A06061 E-Series to Seatalk Adapter Cable is designed to support interfacing an E-Series Classic MFD's (E80, E120) SeaTalk2/NMEA 2000 port to a spur socket within a system's powered and properly terminated SeaTalkng / NMEA 2000 backbone ... this adapter is not applicable to eS-Series MFDs. Instead, an appropriate length of RayNet (F) to RayNet (F) Cable would be used to interface one of the Ethernet Network sockets of the eS-Series MFD to one of the Ethernet Network sockets of the HS5 RayNet Network Switch.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)