Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] p70R adjust waypoint arrivel
04-20-19, 01:09 AM (This post was last modified: 04-23-19 10:25 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] p70R adjust waypoint arrivel
How do I adjust the size of the waypoint arrivel circle, the manual says I can, but how? Also can I skip the next waypoint, when following a route?

Vussi
Find all posts by this user
Quote this message in a reply
04-23-19, 10:31 AM
Post: #2
RE: [CA11] p70R adjust waypoint arrivel
Welcome to the Raymarine Forum Vussi,

The waypoint arrival circle is not configured within an autopilot's settings. Instead, the waypoint arrival circle is configured within the settings of the system's chartplotting product ... in this case, your Axiom MFD. The command sequence HOME->ALARMS->SETTINGS->ARRIVAL RADIUS is used to configured the arrival circle's radius.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)