[TG] [TG11] AIS 650 stops displaying targets
|
05-29-19, 01:42 AM
(This post was last modified: 06-10-19 09:58 AM by Chuck - Raymarine - Moderator.)
Post: #2
|
|||
|
|||
RE: [TG11] AIS 650 stops displaying targets
Hello Tim,
Some questions:
The AIS is designed to be connected over either SeatalkNG or NMEA0183 but not both at the same time, so it's possible - especially if you have two-way NMEA0183 - that this is causing the AIS's software to crash, or similar. Alternatively, perhaps you have a power-supply issue where the AIS's supply voltage is dipping when it tries to transmit and this is causing an internal networking failure. It's not a common issue I've come across personally, so this is a bit speculative. Regards, Tom Raymarine since 1999. Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras Location: Sydney, Australia. Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)