Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] red dots possibly depth how to change?
06-28-19, 05:20 PM (This post was last modified: 07-03-19 11:53 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] red dots possibly depth how to change?
I am trying to figure out what these red dots are on my charts. I am guessing related to depth. I tried changing my minimum draft to 1' and they still show in areas where there is 5-6 feet of water per the chart.

I read the manual and it said during the initial setup that maximum vessel draft, safety margin, and minimum safe depth are set but these can be changed from the settings after initial setup. I cannot find these three categories.

In the attachment I circled the depths...

Any thoughts?

Thanks!


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
07-03-19, 11:55 AM
Post: #2
RE: [CA11] red dots possibly depth how to change?
Welcome to the Raymarine Forum mystery,

Please respond with the approximate coordinates of the location shown within your photo. Please additionally indicate what type of cartography had been selected.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)