The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error

Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom 12 Freeze at boot up and power screen popup
07-15-19, 11:52 AM (This post was last modified: 07-18-19 02:54 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Axiom 12 Freeze at boot up and power screen popup
I have two networked Axiom 12s and I am having a couple of slightly annoying issues:

1. The 2nd unit will freeze at boot up randomly (well at least I think randomly), usually at the picture of the lighthouse. If I cycle the power through the battery switch it still freezes unless I pause the cycle for for 5-10 seconds then it boots up like normal. Any thoughts?

2. On the second unit the power/brightness screen will popup quite a lot, even just sitting at the dock. I switched the power source and cord from the primary unit to the secondary unit. I did this to see if I had a electrical wiring issue (Primary unit has no issues). Primary unit was fine and secondary continued to act up. What I figured out was that if I change the brightness slightly either way the popup stopped... again any thoughts here?

All that being said I can typically resolve issues within a couple of minutes of startup. The systems are on all day and neither issue reappears so not really hampering me but if I could avoid it that would be great. Really love the system especial the auto acquire of targets...

Couple of additional notes:
- I have software version v3.9.46
- I did a soft and factory reset (a couple of times) on the both units after software upgrade


Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
[CA11] Axiom 12 Freeze at boot up and power screen popup - jscname - 07-15-19 11:52 AM

Forum Jump:

User(s) browsing this thread: 2 Guest(s)