Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Interfacing a STST6xxx/ST7xxx/ST8xxx to a third party GPS / Chartplotter
07-31-19, 01:41 PM
Post: #1
Interfacing a STST6xxx/ST7xxx/ST8xxx to a third party GPS / Chartplotter
Interfacing a STST6xxx/ST7xxx/ST8xxx Autopilot Control Head to a third party GPS / Chartplotter

The ST6xxx/ST7xxx/ST8xxx Autopilot Control Heads featured a 4800 BAUD NMEA 0183 v2.0 communications interface to support use with third party GPS / Chartplotting products. Should the third party GPS / Chartplotting product feature a NMEA 0183 communications interface supporting 4800 BAUD NMEA 0183 v2.0 or later communications, then it may be interfaced to the ST6xxx/ST7xxx/ST8xxx Autopilot Control Head's NMEA 0183 IN terminals as follows:
- ST6xxx/ST7xxx/ST8xxx Autopilot Control Head NMEA 0183 IN+ to GPS / Chartplotting product NMEA 0183 OUT+ lead/terminal, and
- ST6xxx/ST7xxx/ST8xxx Autopilot Control Head NMEA 0183 IN- to GPS / Chartplotting product NMEA 0183 OUT- lead/terminal

Alternatively, should the marine electronics system feature a powered and properly terminated NMEA 2000 backbone, then an Actisense NGW-1-ISO NMEA 0183 to NMEA 2000 Data Bridge may be installed as a spur within this backbone. After doing so, the NMEA 0183 output leads of the Actisense NGW-1-ISO NMEA 0183 to NMEA 2000 Data Bridge may be interfaced to the ST6xxx/ST7xxx/ST8xxx Autopilot Control Head's NMEA 0183 IN terminals as follows:
- ST6xxx/ST7xxx/ST8xxx Autopilot Control Head NMEA 0183 IN+ to Actisense NGW-1-ISO NMEA 0183 OUT+ (RED) lead, and
- ST6xxx/ST7xxx/ST8xxx Autopilot Control Head NMEA 0183 IN- to Actisense NGW-1-ISO NMEA 0183 OUT- (BLACK) lead


RAYFAQ#
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)