Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] S100 installation problem
09-29-19, 10:33 AM
Post: #9
RE: [DG11] S100 installation problem
Hi Drek,

Thanks again. I have this weekend:
1.Checked all cables and the yellow one particularly
2. Connected a separate 12V to the base station
3. Exchanged the convertor block with the other (I have got two in my system) elsewhere in the network
4. Connected the base station to the other block
===> in all cases still “NO PILOT”

I had the S100 already checked by the Ray service center in august. I guess it is likely that the S100 is not ok and I will have to send it again?

Please advice.

Regards,

Rene Postulart

(09-24-19 03:02 AM)Derek - Raymarine - Moderator Wrote:  Hi,

This is the latest software version for the converter block.

Either the base station for the remote is faulty and not communicating over SeaTalk or there is a cabling/ connection issue. If you have checked to make sure that the connections to the base station are in good order, check especially continuity in the yellow seaTalk core of the cable from the converter to the base station.

One last thing to try, cut the red core of the cable between the base station and the converter, this will cut off power to the base station, then provide a separate dedicated 12v power to the base station, if this still does not help, then return the base station and remote to an appropriate Raymarine service dealer or to our workshop for further investigation.
Regards
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [DG11] S100 installation problem - Rene.Postulart - 09-29-19 10:33 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)