Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] AIS error message
09-25-19, 01:44 PM (This post was last modified: 09-25-19 02:20 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] AIS error message
What does this error message mean? see pic below. Antenna or unit itself ?
AIS 650 - VHF Ray60 - Axiom Light House 3
It pops up intermittently but persistently - most times it goes away after on clicks OK, twice it needed a whole system reboot to go away.
AIS targets are all showing normally. VHF transmits and receives normally


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
09-25-19, 02:30 PM
Post: #2
RE: [CA11] AIS error message
Welcome to the Raymarine Forum newrule,

It is recommended that you verify that your AIS650 has been updated with the latest available Raymarine product software update, as early software for the AIS650 would trigger VSWR related alarms with antenna/cable assemblies which produced VSWR levels which were within normal ranges. Should the AIS650's software not be current or should you not know, then it would be recommended that the AIS650's software be updated to address this issue. If operating with the latest AIS650 software and should the problem persist, then it would be recommended that the VHF antenna, antenna cable assembly(s), and splitter (if any) be tested to ensure that the measured VSWR is less than that specified within the related FAQ found here. Should the measured VSWR not exceed the value specified within the referenced FAQ, then it would be recommended that the AIS650 be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)