Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [Dh11] windsensor, 30m cable and 14meter mast
09-30-19, 02:25 AM (This post was last modified: 09-30-19 09:03 AM by Derek - Raymarine - Moderator.)
Post: #1
[Dh11] windsensor, 30m cable and 14meter mast
Hello,

The I70 package comes with a windsensor + 30m cable.

Windsensor comes on top of the mast. The mast is 14 meters high and every winter will be removed from the boat. For my top and steam light and VHF cables I have connector on deck, so I can easily unplug these cables and removed the mast.

Is it possible to cut the windsensor cable in half (make connectors on each end) and have those connecters on deck so I can unplug the cable from the mast from the boat?
Instead of having to take a 30m cable out of the boat?


Thanks for letting me know,
Find all posts by this user
Quote this message in a reply
09-30-19, 09:05 AM
Post: #2
RE: [Dh11] windsensor, 30m cable and 14meter mast
Hi Udo,
Thank you for the enquiry,

The normal practice is to cut the cable at the bottom of the mast, leave the cable long enough to run through a gland in the deck and then join the cable inside the boat, (where it is dry), in a waterproof junction box. This will enable the cable to be disconnected at the bottom of the mast when it is removed for winter lay up.

regards

Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)