[CA] [CA11] C80 classic not seeing s1000 auto pilot

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Al1947,

The C-Series Classic MFD Reference Guide may be found here. The Autopilot Controls Transducer Status icon will be superimposed with a red "X" if any one of the following conditions occur:
- the operator has not configured the Autopilot Controls feature (MENU->SYSTEM SETUP->SYSTEM INTEGRATION->AUTOPILOT CONTROLS) to ENABLED
- the MFD has not been interfaced via SeaTalk communications protocol to a compatible Raymarine autopilot
- the MFD has suffered a failure of its SeaTalk communications circuitry.
- the autopilot has suffered a failure of its SeaTalk communications circuitry.
- a device within the SeaTalk bus has suffered a failure of its SeaTalk communications circuitry, causing communication between the MFD and autopilot to not be possible.
- a SeaTalk network hardware (wires, junction blocks, etc.) has occurred.