Raymarine forum

Hi !

I have just started uo my EV 200 linear system. It seems to be working fine but only tried it in calm conditions.

My rudder stops are a bit to weak for the drive- they bend slightly during the dock side calibration, is it possible to enter the rudder stop angle manually to decrease it a few degrees in order to make it stop sooner? I have a working rudder position sensor, EV-1 ACU 200, Linear drive type 1.

Best Regards

Peter

Dear Peter,

You need to set the rudder limits up on the EV200. You can find the instructions here.

Many Thanks
Louise

Thank you, it went quite easy with your support. You might have linked to a different doc. than the applicable one but i found in the Swedish version.

Best Regards and thanks for the support.

Peter

You are welcome.