Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Waypoint Symbol
11-14-19, 12:52 AM (This post was last modified: 11-14-19 09:53 AM by Chuck - Raymarine - Moderator.)
Post: #1
Question [CA11] Waypoint Symbol
Axiom pro 12s 3.10.71, Navionics US-CAD 2015
Is there a way to determine why a route waypoint shows up as a warning signal i.e. a red triangle with an exclamation point? Touching the waypoint icon does not display any info on why it was set to a warning icon when the route was built (by autoroute). Sometimes it’s obvious but other times not.

If there’s not an easy answer to this, perhaps it would be a good enhancement to just be able to touch on the icon and receive the reason for that warning.
Find all posts by this user
Quote this message in a reply
11-14-19, 02:20 PM
Post: #2
RE: [CA11] Waypoint Symbol
Welcome to the Raymarine Forum Micciov,

Unfortunately, the autorouting caution waypoint icons do not currently provide any information concerning the nature of the caution. The most common causes for such caution icons are bridge height and minimum width clearances. A feature request will be logged accordingly to consider providing information concerning the nature of the caution.

Please click here more information concerning product and feature suggestions.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)