Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Backbone Power via ACU-400
01-18-18, 03:43 PM
Post: #1
Backbone Power via ACU-400
I just finished my installation (see diagram attached) and per documentation recommendation and advice on this forum, I powered the backbone from the ACU-400.

After a bit of testing the backbone lost power and I figured out the SeaTalkng power fuse on the ACU-400 was blown.

Turns out this is a 3A fuse, but all the SeaTalk docs talk about 5A fuses.

Is the ACU-400 not sufficient for this purpose? As you can see the backbone is balanced and I followed all other recommendations.

Maybe it was just a fluke, but I figured I should ask to make sure before I take the boat out!


Attached File(s)
.pdf  Simplicity Raymarine Network - 2018-01-12.pdf (Size: 947.89 KB / Downloads: 610)
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)