Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Problem Ais 700
11-29-18, 03:03 PM (This post was last modified: 11-29-18 03:32 PM by Chuck - Raymarine - Moderator.)
Post: #1
[DG11] Problem Ais 700
Hallo,
Today I had a problem with my new Ais 700.
When connected on the 12v power the light goes in green mode,
after 5-6:minutes the light switch in red..
I cannot understand what can be.

If I disconnect the power, and then connect it again goes in green, 5 minutes and again in red :(
Can you help me ??
Thank you.
Antonio.
Find all posts by this user
Quote this message in a reply
11-30-18, 08:54 AM
Post: #2
RE: [DG11] Problem Ais 700
H iToniocask

Thank you for your enquiry

Please can you advise if you have connected PRO AIS2 to the AIS700 and set up the AIS700 complete with MMSI number?

If you connect PROAIS2 to the AIS700 and check the diagnostics this might indicate the nature of the fault.

Regards
Derek
Find all posts by this user
Quote this message in a reply
11-30-18, 03:20 PM (This post was last modified: 11-30-18 03:59 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [DG11] Problem Ais 700
Yes, the set up was made with the mmsi number.
The PROAIS2 diagnostic indicate me this error:
AIS : UTC sync invalid
Thank you
Find all posts by this user
Quote this message in a reply
12-03-18, 09:47 AM
Post: #4
RE: [DG11] Problem Ais 700
Dear Antonio,

There is a new software update for the AIS700 on the Raymarine website see here for software update

This update should correct the alarm.

Regards

Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)