[TG] [TG11] Lighthouse 3 Radar Overlay
|
07-18-18, 01:35 AM
(This post was last modified: 07-18-18 01:21 PM by Chuck - Raymarine - Moderator.)
Post: #2
|
|||
|
|||
RE: [TG11] Lighthouse 3 Radar Overlay
Hello Doug,
On the Chart page/app, go to Menu > Settings (gearbox at the bottom) > Layers > Radar toggle (will only appear when a radar is detected on the network.) The radar needs to be transmitting of course, and if you don't have an autopilot or other source of magnetic heading data then you'll need to enable the setting 'Use radar without heading data' in the Advanced tab. Note that this is off by default because radar overlay from GPS COG is significantly less accurate/reliable than from heading - I personally always recommend using a good-quality source of heading data if using radar overlay. Regards, Tom Raymarine since 1999. Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras Location: Sydney, Australia. Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[TG11] Lighthouse 3 Radar Overlay - Doug Brown - 07-11-18, 11:19 AM
RE: [TG11] Lighthouse 3 Radar Overlay - Tom - Raymarine - Moderator - 07-18-18 01:35 AM
RE: [TG11] Lighthouse 3 Radar Overlay - Doug Brown - 07-18-18, 12:29 PM
RE: [TG11] Lighthouse 3 Radar Overlay - Tom - Raymarine - Moderator - 07-19-18, 01:39 AM
|
User(s) browsing this thread: 1 Guest(s)