[CA] [CA11] Ev100 Proper Torque for BSP Adapters to Pump
|
11-13-18, 10:10 AM
Post: #2
|
|||
|
|||
RE: [CA11] Ev100 Proper Torque for BSP Adapters to Pump
Welcome to the Raymarine Forum bwconquest21,
Like most such hydraulic or threaded plumbing fittings used within an automobile or within one's home, no torque has been specified for the BSP to NPT adapters included the hydraulic pump. One would typically tighten these fittings with a box wrench until the fitting has been firmly tightened. Following installation, connections to the pump would be examined for signs of leakage and then further tightened if any signs of leakage are observed. I did find a web page on related torque for hydraulic fittings on a hydraulic product manufacturer's web site which may be viewed here. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] Ev100 Proper Torque for BSP Adapters to Pump - bwconquest21 - 11-13-18, 08:52 AM
RE: [CA11] Ev100 Proper Torque for BSP Adapters to Pump - Chuck - Raymarine - Moderator - 11-13-18 10:10 AM
RE: [CA11] Ev100 Proper Torque for BSP Adapters to Pump - Oregoncme - 11-19-18, 01:59 PM
RE: [CA11] Ev100 Proper Torque for BSP Adapters to Pump - bwconquest21 - 11-20-18, 12:08 PM
RE: [CA11] Ev100 Proper Torque for BSP Adapters to Pump - Chuck - Raymarine - Moderator - 11-20-18, 01:54 PM
|
User(s) browsing this thread: 1 Guest(s)