The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Raynet cables
12-27-16, 10:12 PM
Post: #1
Raynet cables
I am connecting 2 ES78 MFD's to a network switch and ordered 5 meter and 10 meter Raynet cables to make the connections. When I uncoiled the cables to run them to the network switch I found that both cables had many kinks in the outer jacket. These kinks look like obvious defects in the cables; they are relatively sharp bends that have left "dents" in the jacket of the cables. When running cables I have always avoided sharp bends, and the Raymarine installation manuals all make it clear that sharp bends are not desirable. These cables have built-in sharp bends. Is this the normal state of affairs with Raynet cables, or should I assume that the cables sent to me are defective and return them for replacement?

Thank you,
Bob S
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Raynet cables - BosSH - 12-27-16 10:12 PM
RE: Raynet cables - Istream - 01-10-17, 10:42 AM
RE: Raynet cables - BosSH - 01-10-17, 12:37 PM
RE: Raynet cables - Istream - 01-10-17, 01:45 PM
RE: Raynet cables - BosSH - 01-11-17, 06:48 PM
RE: Raynet cables - BosSH - 01-11-17, 07:44 PM
RE: Raynet cables - Istream - 01-12-17, 10:33 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)