Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Intagration of the ClearCruise System

Post Reply 
 
Thread Rating:
  • 2 Vote(s) - 2.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Intagration of the ClearCruise System
01-23-20, 02:20 PM
Post: #38
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Intagration of the ClearCruise System
Jeff,

Q. I was wondering should I connect the Yellow cable or a white spur cable from the NG converter to the D144 and from there to the E85001?
A. Spur cables and spur (white) sockets within SeaTalkng networking components should only be used to interface a device having a SeaTalkng / NMEA 2000 communications interfaced to the system SeaTalkng / NMEA 2000 backbone. Devices having a SeaTalk communications interface must be interfaced to the system the SeaTalk (yellow) socket of the SeaTalk to SeaTalkng Converter. Accordingly, the SeaTalk to SeaTalkng Converter Cable supplied with the SeaTalk to SeaTalkng Converter Kit will be connected to the SeaTalk (yellow) socket of the SeaTalk to SeaTalkng Converter, which in turn will be connected to the D244 SeaTalk Junction Block. An appropriate length of SeaTalk Cable (w/plug removed from one end) will then be used to connect the D244 SeaTalk Junction Block to either set of the E85001's SeaTalk terminals.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Intagration of the ClearCruise System - Chuck - Raymarine - Moderator - 01-23-20 02:20 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication