[CA] [CA11] Wifi Analyzer shows Quantum and MFD SSIDs, but MFD not pairing?
|
01-14-20, 02:39 PM
(This post was last modified: 01-14-20 02:40 PM by Chuck - Raymarine - Moderator.)
Post: #2
|
|||
|
|||
RE: [CA11] Wifi Analyzer shows Quantum and MFD SSIDs, but MFD not pairing?
Welcome to the Raymarine Forum Peter,
Please click here to view a FAQ addressing this subject. As the NMEA 0183 ports of both the AIS250 and MFD are opto-isolated, I very much doubt that the AIS250 is having any effect upon communications between the Quantum radome and the MFD. Regarding the software level of the Quantum radome, it's recent purchase would not necessarily imply that it has the latest software installed within its memory. Unfortunately, if these two devices are not communicating, then it will not be possible for you to perform the software update. Regarding WiFi signal strength, it is the MFD's signal strength which should be measured at the location of the Quantum radome ... it was unclear which device and where the measurement was taken from based upon your problem description. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] Wifi Analyzer shows Quantum and MFD SSIDs, but MFD not pairing? - PeterCPA - 01-13-20, 07:31 AM
RE: [CA11] Wifi Analyzer shows Quantum and MFD SSIDs, but MFD not pairing? - Chuck - Raymarine - Moderator - 01-14-20 02:39 PM
RE: [CA11] Wifi Analyzer shows Quantum and MFD SSIDs, but MFD not pairing? - PeterCPA - 01-19-20, 07:28 PM
|
User(s) browsing this thread: 1 Guest(s)