[CA] [CA11] Element S Not Syncing with I50 Speed / Depth

[andrew@apwengineering.com]

Hi Chuck another update for you.

1. I was able to get speed from I50 speed instrument to display properly on Element S by configuring MFD display settings
2. Still not able to get depth from Element S to display on I50 depth.
3. Transducer is CPT-S
4. Depth on instrument reads "---"

Both I50 speed and depth are recognized as networked devices on MFD, although the I50 depth takes longer to recognize, and it only seemed to be recognized after I went to Data Sources configuration (I understand this is not required for my setup as I don't have duplicate inputs).

I also connected my MFD to WiFi and installed latest updates - it asked me to reinstall 1.06 for I50 instruments, which I did.

One last thought was perhaps resetting the I50 depth? It has maintained the depth offset value from prior installation somehow (at least I think it was from prior install).

At any rate looking forward to figuring this out.

Regards,

Andy