Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] New pump install
02-27-20, 10:27 AM
Post: #2
RE: [CA11] New pump install
Welcome to the Raymarine Forum Dan,

While the port marked R must be connect to the helm pump reservoir port, such care need not be taken with the A & B ports of the pump. Simply connect them in the easiest manner to the hydraulic lines. After the hydraulic connections have been made and bleeding has been completed, the autopilot should be commanded to turn to starboard. If the pump causes the rudder / lower unit to turn the wrong way, then swap the pump's Motor A/B lead connections course computer / ACU's Motor terminals as you have suggested. If not changing the pump type (ex. Type 1 vs Type 2, etc.), then no other changes need be made to the autopilot's settings.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] New pump install - Rebel112r - 02-26-20, 08:20 PM
RE: [CA11] New pump install - Chuck - Raymarine - Moderator - 02-27-20 10:27 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)