The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] e97 multifunction display not reading navionics card?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] e97 multifunction display not reading navionics card?
03-27-20, 10:12 AM (This post was last modified: 03-27-20 11:09 AM by Chuck - Raymarine - Moderator.)
Post: #1
markriser Offline
Junior Member
**
 		Posts: 2
Joined: Jan 2017
Reputation: 0
[CA11] e97 multifunction display not reading navionics card?
my RM e97 (eSeries) is not reading my navionics card with detail. It shows a very rough chart but not the detailed chart, which I just updated to make sure it was not a chart issue.

I am not sure if it's not reading the SD card (navionics) correctly or if it is a disk slot issue.

It has done this off and on since I've owned the unit and I can no more figure out why it does it vs why it magically starts reading the detailed navionics chart correctly.

PS I also reset the MFD recently
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] e97 multifunction display not reading navionics card? - markriser - 03-27-20 10:12 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication