[CA11] ST60 repeater issue

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] ST60 repeater issue

03-31-20, 08:47 AM (This post was last modified: 03-31-20 09:35 AM by Chuck - Raymarine - Moderator.)

Post: #1

syfreedom Offline

Junior Member

Posts: 4
Joined: Jul 2018
Reputation: 0

[CA11] ST60 repeater issue

I am feeding nmea1083 data stream in to the yellow pin (beside the power input). The data comes from a raspberry pi4 TxD pin. The data sentences are of the format:
$ARMWV,294.44,R,7.49,N,A*2b

The ST60 display is in repeater mode but it is not reacting to the nmea feed. Any ideas of what could be the culprit here?

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] ST60 repeater issue - syfreedom - 03-31-20 08:47 AM

RE: [CA11] ST60 repeater issue - Chuck - Raymarine - Moderator - 03-31-20, 09:36 AM

RE: [CA11] ST60 repeater issue - syfreedom - 04-01-20, 02:36 AM

RE: [CA11] ST60 repeater issue - Chuck - Raymarine - Moderator - 04-01-20, 07:58 AM

User(s) browsing this thread: 1 Guest(s)