Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Data selection not possible
04-13-20, 12:51 PM (This post was last modified: 04-13-20 12:52 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Data selection not possible
Welcome to the Raymarine Forum ocgrant,

Regarding the radar software update. Please note that there are end user radar software updates for any models of open array radar pedestals and radomes except for Magnum and Quantum / Quantum 2 respectively. Accordingly, you should not attempt to update the software within your 4KW HD open array pedestal.

Rest assured that LightHouse II v19.03 software is indeed compatible with the Raystar 130 GPS Sensor. It is first recommended that you use the Select Device list feature of LightHouse II and then double click on the Raystar 130 GPS Sensor from within the displayed list doing so will list its details. Should the boot code version for your Raystar 130 GPS Sensor be listed as v1.14, then the GPS Sensor's boot code will need to be updated to v1.15 before its application software can be updated to v3.03. Both the boot code and application code software downloads may be found on the Raystar 130 GPS Sensor Software Update web page. The microSD card should initially be populated with the boot code .iso file for the Raystar 130 GPS Sensor. After installing the boot code for the Raystar 130 GPS Sensor, then the microSD card's contents should be erased, and then the microSD card may then be populated with the v3.30 software update .iso file.

Should the Data Source Selection problem persist thereafter, then please list the makes & models each device which has been installed within your marine electronics system.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Data selection not possible - Chuck - Raymarine - Moderator - 04-13-20 12:51 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)