e127 and ST60 Autopilot
|
08-04-16, 12:10 PM
(This post was last modified: 08-08-16 01:52 PM by Chuck - Raymarine - Moderator.)
Post: #7
|
|||
|
|||
RE: e127 and ST60 Autopilot
Chuck,
When entering a single waypoint (go to cursor for example) or starting an autoroute I have to repeatedly (over and over again) respond to the "change status" message on the screen until it stops appearing. It comes up multiple times even when going to a single "go to cursor" waypoint and loads of times when starting on a multi waypoint autoroute. Am I doing something wrong here?? Thanks! |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
e127 and ST60 Autopilot - cbd@gov-consult.com - 06-14-16, 09:17 AM
RE: e127 and ST60 Autopilot - Chuck - Raymarine - Moderator - 06-14-16, 09:41 AM
RE: e127 and ST60 Autopilot - cbd@gov-consult.com - 06-25-16, 07:25 AM
RE: e127 and ST60 Autopilot - Chuck - Raymarine - Moderator - 06-27-16, 10:51 AM
RE: e127 and ST60 Autopilot - cbd@gov-consult.com - 07-05-16, 12:48 PM
RE: e127 and ST60 Autopilot - Chuck - Raymarine - Moderator - 07-05-16, 01:54 PM
RE: e127 and ST60 Autopilot - cbd@gov-consult.com - 08-04-16 12:10 PM
RE: e127 and ST60 Autopilot - Chuck - Raymarine - Moderator - 08-26-16, 08:43 AM
RE: e127 and ST60 Autopilot - cbd@gov-consult.com - 08-26-16, 02:16 PM
RE: e127 and ST60 Autopilot - Chuck - Raymarine - Moderator - 08-26-16, 02:52 PM
|
User(s) browsing this thread: 1 Guest(s)