SeaTalkNG power with ACU-400 - Best Practices
|
06-18-16, 01:16 PM
(This post was last modified: 06-20-16 10:10 AM by Chuck - Raymarine - Moderator.)
Post: #5
|
|||
|
|||
RE: SeaTalkNG power with ACU-400 - Best Practices
Thank you Chuck.
Since it appears that pushing rudder data to ST via the STNG gateway is not supported and that the Evolution AP cannot make use of RFU data via ST (other than to display on STNG instruments like the P70R), then I'm going to take the ST60 RAI off of the ST network and go back to operating it standalone. And I'll have to think about whether I want to run a second RFU or whether I should go back to "Y"-ing the signal from the one I have and just putting up with the needle dithering. Or maybe dump the ST60 RAI altogether and just use the ribbon atop my P70R. Lulu: 36' Little Harbor WhisperJet Raymarine: Axiom 12 RV, RV200, Axiom 12 Pro, Evo 1/ACU 150/P70RS, Quantum Q24C, HS5 ---previous---- Refugio: 44' trawler Raymarine: ACU-400, EV-1, P70R, a78, M81105 RFU, ST60 RAI, E22158 ST-STNG NMEA 2000: Garmin 740S & GMR18 HD, Airmar WS-200WX, Actisense NGT-1 |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
SeaTalkNG power with ACU-400 - Best Practices - Keith Pleas - 06-15-16, 06:30 PM
RE: SeaTalkNG power with ACU-400 - Best Practices - Chuck - Raymarine - Moderator - 06-16-16, 03:37 PM
RE: SeaTalkNG power with ACU-400 - Best Practices - Keith Pleas - 06-16-16, 06:11 PM
RE: SeaTalkNG power with ACU-400 - Best Practices - Chuck - Raymarine - Moderator - 06-17-16, 10:00 AM
RE: SeaTalkNG power with ACU-400 - Best Practices - Keith Pleas - 06-18-16 01:16 PM
RE: SeaTalkNG power with ACU-400 - Best Practices - Chuck - Raymarine - Moderator - 06-20-16, 10:09 AM
|
User(s) browsing this thread: 1 Guest(s)