Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Evoluion will not working properly
08-25-16, 03:41 PM
Post: #2
RE: Evoluion will not working properly
Welcome to the Raymarine Forum Saltydawg,

Approximately how fast was the boat operating when you observed the reported autopilot behavior?

What have you configured the autopilot's Response Level to?

When examining the autopilot's diagnostics, what was the maximum deviation value detected by the autopilot?

Has the autopilot been fitted with a rudder reference transducer? When tied to dockside, at anchor, or while drifting, if the the vessel's wheel is turned to starboard, does the autopilot's rudder bar indicate that the rudder has moved to starboard? When the vessel's wheel is turned to port, does the autopilot's rudder bar indicate that the rudder has moved to port?

While still stationary, if the the autopilot is commanded into AUTO and then +10 degrees of turn is commanded, does the rudder bar indicate that the rudder has moved to starboard as a result of the command? While still stationary, if the the autopilot is commanded into AUTO and then -10 degrees of turn is commanded, does the rudder bar indicate that the rudder has moved to port as a result of the command?

Is the vessel fitted with a speed through water sensor (ex. fishfinder transducer w/paddlewheel, etc.)?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Evoluion will not working properly - Chuck - Raymarine - Moderator - 08-25-16 03:41 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)