ST70 wont run calibrate vane test
|
08-29-16, 11:46 AM
Post: #1
|
|||
|
|||
ST70 wont run calibrate vane test
Hello I am hoping you can help me with an issue.
I recently removed a faulty wind pod with an iTc-5. The replacement went well and the wind speed and instrument readings look reasonable. I assume I need to calibrate the vane to the new transducer. Through the ST70 I have attempted the calibrate wind vane (where you go in slow circles) many times without success. It either "hangs up" at the 6% complete mark or stays at 0% no matter how long I go in circles. It doesn't say to slow down or anything. The small blue circle shows it is "working" during the test but the test will not progress and complete. I can align the vane (head into the wind to adjust AWA) no problem. As a result of not getting this alignment to work the true wind and angle is way off. My software version on the ST70 is 3.03. Please help! |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
ST70 wont run calibrate vane test - Andrew41 - 08-29-16 11:46 AM
RE: ST70 wont run calibrate vane test - Chuck - Raymarine - Moderator - 08-29-16, 01:01 PM
RE: ST70 wont run calibrate vane test - Andrew41 - 09-12-16, 06:39 PM
RE: ST70 wont run calibrate vane test - Chuck - Raymarine - Moderator - 09-14-16, 09:30 AM
RE: ST70 wont run calibrate vane test - Andrew41 - 09-14-16, 03:02 PM
RE: ST70 wont run calibrate vane test - Chuck - Raymarine - Moderator - 09-14-16, 03:41 PM
RE: ST70 wont run calibrate vane test - Andrew41 - 09-24-16, 11:50 AM
RE: ST70 wont run calibrate vane test - Chuck - Raymarine - Moderator - 09-26-16, 08:29 AM
|
User(s) browsing this thread: 1 Guest(s)